Points to pay attention to when running Micra-10 sharpening machine
should meet the requirements of this standard and manufacture according to the drawings and technical documents approved by the prescribed procedures so that the use of the sharpener can better. And the understanding and observance of the dry running requirements are necessary. In the application of the sharpener, when the air is running, the full-fast fasteners are required to fasten and loose. The grinding length of the heavy-duty sharpener should easily adjust with the change of product specifications. And the locking is reliable and heavy. In addition to the fixed tool holder, the sharpening angle of the sharpener should easily adjust as needed. When the machine is moving, all departments are in harmony. There should no abnormal sound, the lubrication of the movement and working parts should reliable. And the lubrication system should have no oil leakage.
The Correct Operating Procedure OF Micra-10 Sharpening Machine
as a machine for grinding metal equipment. The correct operation is not only to ensure the normal operation of the machine, but also to ensure that personal injury is particularly important. So, what is the correct operation procedure of the sharpener. The following Micra-10 sharpening machine manufacturer Demina will explain it for you.
1. Before operating the machine, please read the instructions carefully to prevent accidents and accidental injuries.
2. Check whether the three-phase four-wire power is normal and whether the running direction of the grinding head and the grinding wheel is consistent with the direction indicated by the stroke button.
3. During the operation of the machine, the oil should be lubricated at any time on the track to prevent the track from being worn due to lack of oil.
4. In the process of calibrating, if there is any error in the left and right, it can be adjusted by the adjusting screw on the tool holder.
5. In the process of sharpening the knife, it should note that the amount of the feed can not be too large, generally controlled between 0.01 and 0.02 mm. In case the feed amount is too large, causing the paste knife and the heat to be too high to deform the blade so that the blade is ground. The cutting edge is not in a straight line.
6. When there is a burr on the edge of the blade, it means that the blade has been ground. No need to feed the knife until the spark is small. Remove the blade and use the oil stone to deburr.
7. When Micra-10 sharpening machine, not in use, the water stain on the knife holder must wipe clean with butter or oil to prevent rust.
8. The oil filling hole on the sharpening machine must fill with oil before going to work every day.
9. The user must concentrate on the process of sharpening the knife and the process of taking the blade to prevent personal injury caused by danger.
The working process of the sharpening machine is almost the same. Everyone strictly follows the above process to operate the sharpening machine. It should not cause too much mechanical failure or personal injury.
Demina Micra-10 sharpening machine for sale, welcome to come and consult.
